CVE-2025-39801

About vulnerability

In the Linux kernel, the following vulnerability has been resolved:

usb: dwc3: Remove WARN_ON for device endpoint command timeouts

This commit addresses a rarely observed endpoint command timeout which causes kernel panic due to warn when ‘panic_on_warn’ is enabled and unnecessary call trace prints when ‘panic_on_warn’ is disabled. It is seen during fast software-controlled connect/disconnect testcases. The following is one such endpoint command timeout that we observed:

1. Connect ======= ->dwc3_thread_interrupt ->dwc3_ep0_interrupt ->configfs_composite_setup ->composite_setup ->usb_ep_queue ->dwc3_gadget_ep0_queue ->__dwc3_gadget_ep0_queue ->__dwc3_ep0_do_control_data ->dwc3_send_gadget_ep_cmd

2. Disconnect ========== ->dwc3_thread_interrupt ->dwc3_gadget_disconnect_interrupt ->dwc3_ep0_reset_state ->dwc3_ep0_end_control_data ->dwc3_send_gadget_ep_cmd

In the issue scenario, in Exynos platforms, we observed that control transfers for the previous connect have not yet been completed and end transfer command sent as a part of the disconnect sequence and processing of USB_ENDPOINT_HALT feature request from the host timeout. This maybe an expected scenario since the controller is processing EP commands sent as a part of the previous connect. It maybe better to remove WARN_ON in all places where device endpoint commands are sent to avoid unnecessary kernel panic due to warn.

Affected product:

AlmaLinux 9.2 ESU , CentOS 7 ELS , CentOS 8.4 ELS , CentOS 8.5 ELS , CentOS Stream 8 ELS , CloudLinux 7 ELS , Oracle Linux 7 ELS , RHEL 7 ELS , TuxCare 9.6 ESU , Ubuntu 16.04 ELS , Ubuntu 18.04 ELS , Ubuntu 20.04 ELS

Affected packages:

kernel @ 4.18.0 (+13 more)

In the Linux kernel, the following vulnerability has been resolved:

usb: dwc3: Remove WARN_ON for device endpoint command timeouts

This commit addresses a rarely observed endpoint command timeout which causes kernel panic due to warn when ‘panic_on_warn’ is enabled and unnecessary call trace prints when ‘panic_on_warn’ is disabled. It is seen during fast software-controlled connect/disconnect testcases. The following is one such endpoint command timeout that we observed:

1. Connect ======= ->dwc3_thread_interrupt ->dwc3_ep0_interrupt ->configfs_composite_setup ->composite_setup ->usb_ep_queue ->dwc3_gadget_ep0_queue ->__dwc3_gadget_ep0_queue ->__dwc3_ep0_do_control_data ->dwc3_send_gadget_ep_cmd

2. Disconnect ========== ->dwc3_thread_interrupt ->dwc3_gadget_disconnect_interrupt ->dwc3_ep0_reset_state ->dwc3_ep0_end_control_data ->dwc3_send_gadget_ep_cmd

In the issue scenario, in Exynos platforms, we observed that control transfers for the previous connect have not yet been completed and end transfer command sent as a part of the disconnect sequence and processing of USB_ENDPOINT_HALT feature request from the host timeout. This maybe an expected scenario since the controller is processing EP commands sent as a part of the previous connect. It maybe better to remove WARN_ON in all places where device endpoint commands are sent to avoid unnecessary kernel panic due to warn.