Overview
About vulnerability
In the Linux kernel, the following vulnerability has been resolved: spi: tegra210-quad: Fix timeout handling When the CPU that the QSPI interrupt handler runs on (typically CPU 0) is excessively busy, it can lead to rare cases of the IRQ thread not running before the transfer timeout is reached. While handling the timeouts, any pending transfers are cleaned up and the message that they correspond to is marked as failed, which leaves the curr_xfer field pointing at stale memory. To avoid this, clear curr_xfer to NULL upon timeout and check for this condition when the IRQ thread is finally run. While at it, also make sure to clear interrupts on failure so that new interrupts can be run. A better, more involved, fix would move the interrupt clearing into a hard IRQ handler. Ideally we would also want to signal that the IRQ thread no longer needs to be run after the timeout is hit to avoid the extra check for a valid transfer.Details
KernelCare state
Live-patch status from KernelCare for each operating system.
| Operating system | Status | Covered kernels |
|---|---|---|
| Debian 12 | Planned | — |
| Debian 13 | Will Not Fix | — |
| Oracle Linux 8 UEK 7 | Will Not Fix |
85 kernels
|
| Oracle Linux 9 UEK 7 | Will Not Fix |
85 kernels
|
| Proxmox VE 7 5.15 | Released |
47 kernels
|
| Ubuntu 20.04 HWE AWS | Released |
57 kernels
|
| Ubuntu 20.04 HWE Azure | Released |
40 kernels
|
| Ubuntu 22.04 | Released |
90 kernels
|
| Ubuntu 22.04 AWS | Released |
81 kernels
|
| Ubuntu 22.04 Azure | Released |
73 kernels
|
| Ubuntu 24.04 | Will Not Fix |
41 kernels
|
| Ubuntu 24.04 AWS | Planned | — |